Table of Contents
Advertisement
LED Strip Installation
LED Strip Instructions
Power to the unit MUST be disconnected before installing
For instructions on how to remove the door please see the
door install/removal section.
For instructions on how to remove the burner tray please
see the burner tray section.
1. Secure LED receiver and AC adaptor to the bottom inside face
of the firebox with Velcro strips.
Figure 25. Secure LED receiver
2. Insert and secure LED plate.
Figure 25.b Secure LED plate
3. Connect LED strip to LED receiver, and power to AC adaptor.
Figure 25.c Power LED receiver
XG0222
4. Place Glass plate where metal plate sat before, secure using
existing metal brackets. Screw in halfway on one side first,
then fully on the other side, then fully tighten first side.
Figure 25.d Insert glass plate
5. Reinstall burner strip.
Figure 25.e Insert burner
6. Reinstall media tray.
Figure 25.f Insert media tray
7. Reinstall pilot cover and door/screen.
Figure 25.g Insert pilot cover/door/screen
Installation
35
Advertisement
Table of Contents
