Table of Contents
Advertisement
Section A: Before You Begin
IMPORTANT MESSAGE: SAVE THESE INSTRUCTIONS
The Exemplar fireplaces must be installed in accordance with these
instructions. Carefully read all the instructions in this manual first.
Consult the Local Gas Branch to determine the need for a permit prior
to starting the installation. It is the responsibility of the installer to
ensure this fireplace is installed in compliance with the manufacturers
instructions and all applicable codes.
NOTICE
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control that
has been under water
NOTICE
Due to high temperatures, the appliance should be located out of
traffic and away from furniture and draperies
NOTICE
Children and adults should be alerted to the hazards of high surface
temperature and should stay away to avoid burns or clothing ignition
NOTICE
A barrier designed to reduce the risk of burns from the hot viewing
glass is provided with this appliance and shall be installed for the
protection of children and other at-risk individuals
NOTICE
Installation and repair should be done by a qualified service person.
The appliance should be inspected before use and at least annually
by a professional service person. More frequent cleaning might be
required due to excessive lint from carpeting, bedding material, etc. It
is imperative that control compartments, burners, and circulating air
passageways of the appliance be kept clean
4
Installation Checklist
• Determine the desired install location of your fireplace.
• See Section 1, Dimensions and refer to the Framing Section 2 for
details.
• Select your type and location of your Power Vent run: Roof Mounted
PVVEX510-300, External Wall Mounted PVHEX510-300, Flush Louver
Wall Mounted PVHFL510-300.
• Your termination location should be selected to provide the most
efficient vent run.
• Lay out the Vent run; calculating the required elbows and straight
runs of 5"/10" flex and/or rigid pipe. (5"/8" for R320 and R420)
• Refer to the Section 3, "Venting" for details.
• Montigo supplies 20' of low voltage wire, which can be spliced to a
maximum of 100' with wire of equal quality. This wire CANNOT run
in conduit with any other wire.
• Refer to Section 4, for Wiring Details.
• The gas connection is located on the bottom right side (pilot burner
side) of the fireplace.
• Refer to local codes and guidelines for installation requirements.
• Refer to Section 5, "Installing the Gas Line" for details.
• Installation and repairs should be done by a qualified contractor
and must conform to:
• Installations in Canada must conform to the local codes or in the
absence of local codes to the current version of Natural Gas and
Propane Installation Code, CSA B149. Electrical Installations must
conform to the local codes or, in the absence of local codes, to
the current version of Canadian Electrical Code, CSA C22.1.1
• Installations in the USA must conform to the local codes or in the
absence of local codes to the current version of National Fuel
Gas Code, ANSI Z223.1/NFPA 54. Electrical Installations must
conform to the local codes or, in the absence of local codes, to
the current version of the National Electrical Code, ANSI/NFPA 70.
See Appendix C for installation within the State of Massachusetts.
NOTICE
Clothing or other flammable material should not be placed on or near
the appliance
General
XG0231 - 061120
Advertisement
Table of Contents
