Paradyne FrameSaver 9120 User Manual page 63

9121-A2-GB20-20
Message
mm/dd/yy hh:mm:ss –
Yellow alarm signal
received at the
[ Network/DSX-1 ]
Interface.
mm/dd/yy hh:mm:ss –
Alarm Cleared for Yellow
alarm signal at the
[ Network/DSX-1 ]
Interface.
mm/dd/yy hh:mm:ss –
A DBM Card Failure has
been detected.
Alarm Cleared for a DBM
Card Failure.
mm/dd/yy hh:mm:ss –
An ISDN Network Failure
has been detected
(active).
mm/dd/yy hh:mm:ss –
Alarm Cleared for an
ISDN Network Failure.
mm/dd/yy hh:mm:ss –
The Frame Relay Logical
Link is down on the [ T1
Network/ Port-1/ Port-2/
BRI-B1/BRI-B2 ]
Interface.
mm/dd/yy hh:mm:ss –
Alarm Cleared. The
Frame Relay Logical Link
is up on the [ T1
Network/ Port-1/ Port-2/
BRI-B1/BRI-B2 ]
Interface.
May 1998
Maintenance and Troubleshooting
What It Indicates
A Yellow alarm signal is
detected on the network
or DSX-1 interface.
Alarm condition no
longer exists.
A DBM Card Failure
condition has been
detected at the specified
date (month/day/year)
and time
(hour:minute:second).
Alarm condition no
longer exists.
ISDN Network Failure
condition has been
detected at the specified
date (month/day/year)
and time
(hour:minute:second).
Alarm condition no
longer exists.
Frame relay Link Status
has been enabled or
disabled.
Network has reported
that the frame relay Link
Status has changed; it
has been enabled or
disabled.
Alarm condition no
longer exists.
What To Do
1. Check the Network and/or
DSX-1 cable.
2. Contact network provider for
Network interface problem.
Check equipment for DSX-1
interface problem.
No action needed.
Call your service representative
for assistance.
No action needed.
Check the network
connection.
Contact network provider.
No action needed.
Verify that Link Status is
enabled on the access unit
identified.
Verify that LMI Personality is
set to User Side.
Check Service Log; counter
may have been reset.
No action needed.
5-7