Paradyne FrameSaver 9120 User Manual page 31

9121-A2-GB20-20
Health and Status Messages:
These messages appear in the left column of the System and Test Status screen,
or the highest priority Health and Status message appears on the last line at the
bottom of the screen (right corner).
Message What It Indicates
AIS at Network An Alarm Indication Signal
(AIS) is received by the
network interface. AIS is an
unframed, all ones signal.
1. Upstream access unit is
2. The network is
AIS at DSX-1 An Alarm Indication Signal
(AIS) is received by the
DSX-1 interface. AIS is an
unframed, all ones signal.
Backup Active Backup has been
established and data is
flowing over the alternate
DLCI.
BRI-B n Call Profile ISDN backup call (manual
Disabled or automatic) could not be
made because the Call
Profile had been disabled.
BRI-B n Call Profile ISDN backup call (manual
Invalid or automatic) could not be
made because the Call
Profile is invalid.
Configuration Shortcut Configuration Shortcuts
Active feature is active, which
allows automatic
configuration and
cross-connection of DLCIs
as they are activated by the
network.
CTS down to Port- n The Port n CTS control
Device lead on the access unit is
off.
DBM Download A download attempt was
Required interrupted and failed to
complete.
There are incompatibilities
between the NAM and
DBM software.
Only appears when a dial
backup module (DBM) is
installed.
transmitting AIS
(keep-alive signal).
transmitting an AIS.
May 1998
Displaying System Information
What To Do
1. Check status of upstream
access unit(s).
2. Report problem to carrier.
Check the DTE attached to the
DSX-1 interface.
No action needed.
Enable the ISDN Call Profile
( Main Menu Control
ISDN Call Profiles Enable )
1. Verify that the ISDN Call
Profile identifier is not blank.
2. Check that the phone number
associated with the ISDN Call
Profile is valid.
No action needed unless you
want to disable this feature,
selected from the Main Menu.
1. Verify that the port is enabled.
2. Check DTR from Port-1 or
Port-2.
Download function is controlled
and for service personnel only.
Call your service
representative.
4-5