hatch comfort TAURAUS C1 User's Operating Manual page 40

Doc -030
Light intensity
Illumination
Remark) The light intensity shown is based on the distance of 700mm from the light source to an object.
Remark) The illumination range may vary according to the direction of the lamp
NOTE
By default, the filament direction of the lamp is set vertically.
If the direction is adjusted horizontally, the illumination range gets smaller and
the light intensity becomes stronger.
8.10.5 Adjustment of light intensity in 3 steps (Option)
▶ Press
Press it again to turn off the operating light.
▶ While the light is ON, press
increase the light intensity (in the sequence of L -> M -> H).
▶ Adjust the filament direction of the lamp with 'Filament direction adjustment knob'.
by loosening the knob and turning it along with the guide rail to rotate the lamp.
After controlling the direction of the lamp, tighten the knob.
Depending on the degree of rotation, illumination range and intensity change.
Light intensity
Remark) The light intensity shown is based on the distance of 700mm from the light source to an object.
Remark) The illumination range may vary according to the direction of the lamp
NOTE
By default, the filament direction of the lamp is set vertically.
If the direction is adjusted horizontally, the illumination range becomes smaller.
Revised on 15/06/2021
Category
Low mode
High mode
X
range
Y
switch on the dentist control panel to turn on the operating light.
Category
Low
Middle
High
Illumination
X
range
Y
Hatch comfort C1 User manual
Light intensity depending on filament direction
Vertical
about 7,500 ㏓
about 24,000 ㏓
130㎜
70㎜
switch until sounding of an alarm and release it to
Light intensity depending on filament direction
Vertical
about 7,500 ㏓
about 19,000 ㏓
about 24,000 ㏓
130㎜
70㎜
Horizontal
170㎜
45㎜
filament.
Horizontal
170㎜
45㎜
filament.