hatch comfort TAURAUS C1 User's Operating Manual page 27

Doc -030
▶ How to program a new position
1) With the manual positioning switch or the foot controller, move the chair to desired
position.
2) Press and hold the switch you want to program (Zero position, AP1, AP2) for 3
seconds.
3) When an alarm is heard, programming is done.
Position programming is available only for the dentist panel.
NOTE
When pressing the mouth rinsing position, the backrest moves to the same
position you program for Zero position.
CAUTION
Keep an eye on the patient when operating the chair.
▶ For an emergency stop when the chair is moving to a programmed position,
press any control switches in the dentist and assistant panel or a foot controller pedal.
8.6.3 Function and Menu control
WARNING
When replacing tips and burs of instruments, stop the chair operation
completely.
▶ Otherwise, serious accident or injury may occur.
Revised on 15/06/2021
Zero position Chair moves to the patient entry/exit position.
Chair moves to Auto Position 1 programmed
AP 1
for treatment.
Chair moves to Auto Position 2 programmed
AP 2
for treatment.
Chair moves to the previous position.
Soft memory
(normally used after mouth rinsing)
Hatch comfort C1 User manual