Resetting The Application Parameters To Factory Default Settings - Phoenix Contact CAPAROC Series User Manual

Table 7-13

Resetting the application parameters to factory default settings

Byte Data Data
offset type
0 Byte 10 = reset power module
20 = reset power module and all circuit breaker modules
109745_en_01
7.2.1.5 Resetting the application parameters to factory default settings
(index 000F
This index allows the application parameters to be reset to factory default settings and is not
part of the startup parameterization. For example, the WRREC block is used to write to this
index. Only application parameters are reset with this index. The communication parame-
ters, such as the station name, I&M data, and IP addresses are retained.
Process, parameter, and diagnostic data
)
hex
Access Default setting
w -
PHOENIX CONTACT
47 / 66