Mounting the current rail
Snapping on the modules
109745_en_01
4.3
Mounting the modules
Please refer to Section
No tools are required to mount the CAPAROC system.
•
First, mount the end bracket on the DIN rail.
•
Then install the current rail on the DIN rail.
•
Use an appropriately sized current rail for the application.
•
If one current rail is not enough, you can extend it with an additional current rail.
•
To connect them, insert the next current rail in the connection of the preceding one.
Current rails are available with different overall widths. Select the appropriate length
for your application from the overview in
page
12.
Place the power module and circuit breaker modules onto the current rail and DIN rail verti-
cally until they snap into place. Make sure that the device plugs for the current rail are posi-
tioned above the corresponding opening on the current rail. Use the guide slots on the hous-
ing sides to connect the modules together.
Figure 4-2
Snapping on the modules
"Safety notes for mounting and removal" on page 23
Section "CAPAROC current rails" on
Mounting and removing modules
PHOENIX CONTACT
25 / 66