Global Switch-On Delay; Global Operating Mode - Phoenix Contact CAPAROC Series User Manual

CAPAROC system
Table 7-11

Global switch-on delay

Byte Data Data
offset type
0 Word Delay (HIGH byte)
1 Delay (LOW byte)
Table 7-12

Global operating mode

Byte Data Data
offset type
0 Byte 0 = independent operation
1 = wait for fieldbus
2 = no change
46 / 66
PHOENIX CONTACT
7.2.1.3 Global switch-on delay (index 000D
The switch-on delay configures the time interval between switching on channels. The val-
ues listed below can be selected in the engineering with the GSD. The switch-on delay can
also be freely programmed with the acyclic WRREC block (except for value 65535/FFFF-
).
hex
The delay applies to all circuit breaker modules in the system.
Possible settings:
0 = minimum delay*
25 = 25 milliseconds
50 = 50 milliseconds
100 = 100 milliseconds
150 = 150 milliseconds
200 = 200 milliseconds
500 = 500 milliseconds
65535 = no change
* Depending on the system, there is always a delay of a few milliseconds
7.2.1.4 Global operating mode (index 000E
This index configures the operating mode of the device after the voltage reset. In indepen-
dent operation, the channels that were switched on prior to the voltage reset are switched
on again. In the case of the "Wait for fieldbus" option, the output channels are only switched
on again once the PROFINET connection has been established.
)
hex
Access Default setting
r/w 50
)
hex
Access Default setting
r/w 0
109745_en_01