Wexiodisk WD-6 Installation And User Manual page 38

Operating instructions
WD-6 and WD-7
•
•
•
•
•
•
WD-6 DUPLUS and WD-7 DUPLUS
•
•
•
•
•
•
Glasstilt
Switch on the power using the 0/1 button (9) on the panel.
Close the hood. On machines with automatic hood lift, the hood is closed
by pressing button (5). The filling and heating process will begin.
The display (2) shows the temperature in the booster heater until the
machine has been filled. The display (4) shows "P0". P0 is a pause mode
which indicates that no washing programme has been selected. The
symbol (3) is lit during filling.
Once the dishwasher is full, the symbol (1) lights up and the display (2)
shows the temperature of the washing water. If the washing temperature
falls below the set value by more than 5°C, the temperature shown on the
display (2) flashes. The temperature on the display will also flash if the
washing temperature is below 50°C.
The water in the washing tank will continue to be heated until the correct
washing temperature has been reached. The normal operating
temperature for the washing phase is 60° C. The machine can be set up so
washing cannot start until the correct washing temperature has been
reached.
Once the correct temperature has been reached, the washing pump will
start and run for a short period to mix the detergent.
Switch on the power using the 0/1 button (9) on the panel.
Close the hood. On machines with automatic hood lift, the hood is closed
by pressing button (5). The filling and heating process will begin.
The display (2) shows two dashes "--" until the machine has been filled.
The display (4) shows "P0". P0 is a pause mode which indicates that no
washing programme has been selected. The symbol (3) is lit.
Once the dishwasher is full, the symbol (1) lights up and the display (2)
shows the temperature of the washing water. If the washing temperature
falls below the set value by more than 5°C, the temperature shown on the
display (2) flashes. The temperature on the display will also flash if the
washing temperature is below 50°C.
The water in the washing tank will continue to be heated until the correct
washing temperature has been reached. The normal operating
temperature for the washing phase is 60° C. The machine can be set up so
washing cannot start until the correct washing temperature has been
reached.
Once the correct temperature has been reached, the washing pump will
start and run for a short period to mix the detergent.
34
Rev. 2.0 (202202)