Table of Contents
Advertisement
When you press button (4) to confirm the fourth and
last digit, the MEM item frame (C, Fig 57) is flashing.
Now you can use buttons (1) and (2) to do the
following:
-
select "EXIT" (flashing frame) and press button
(4) to quit without saving the PIN CODE;
-
select every figure (flashing) of the set code and
press button (4) to edit them and repeat the
code entry procedure;
-
select "MEM" (flashing frame) (C, Fig 57) and
press button (4) to save the new PIN CODE.
The instrument panel will then show "MEM OK"
for 2 seconds, then will show "EXIT" with
flashing frame.
To quit, press button (4).
Note
You can change your PIN CODE an unlimited
number of times.
84
1
4
2
Fig 58
Advertisement
Table of Contents
