Installing The Tailpipe Extension - Toro Z Master 2000 Series Operator's Manual

3
Installing the Tailpipe
Extension
Parts needed for this procedure:
1 Tailpipe extension
1 Washer-head screw (#8 x 1/2 inch, self-threading)
Procedure
Install the tailpipe extension as follows:
1. Locate the muffler tailpipe at the lower left corner of
the engine.
Note: If you need additional room to install the
tailpipe extension, do the following steps:
A. Remove the 3 flange nuts that secure lower-left
engine guard to the machine
Note: Retain these parts.
(Figure 5).
8
3
1
3
2
Figure 5
Lower-Left Engine Guard
1. Lower-left engine guard
(US domestic mowers)
2. Lower-left engine guard
(International mowers)
3. Carriage bolt (front mount
point)
B. Remove the 2 carriage bolts at the front-mount
point and the lower-left engine guard.
Note: Retain these parts. Do not remove the
carriage bolt at the center engine guard.
2. Measure 19 mm (3/4 inch) along the outside of the
muffler tailpipe, from the outlet end moving toward the
muffler as illustrated in
of the tailpipe at this measurement.
4
5
6
4
5
3
6
G018372
4. Flange nut
5. Carriage bolt (center
engine guard)
6. Muffler tailpipe
(Figure
Figure 6, and mark the surface
3
5).