Toro Z Master 2000 Series Operator's Manual page 21

1
2
G018439
Figure 28
Drilling Lower Discharge Tube
1. White dot
2. Lower discharge tube
3. Drill 6.5 mm (1/4 inch)
diameter hole
C. Remove and retain the hardware in the lower end
of the upper discharge tube.
Note: The holes in the lower end of the upper
discharge tube are spaced an equal distance
around the tube circumference.
D. Align one of the pre-drilled holes at the lower end
of the upper discharge tube with the hole in the
upper end of the lower discharge tube that was
drilled in step B (Figure
E. Insert a screw (1/4 x 3/4 inches) through one of
the holes to maintain the alignment of the upper
and lower tubes
4
3
5
4. Upper discharge tube
5. Screw (1/4 x 3/4 inch)
6. Upper discharge-tube hole
28).
(Figure 28).
F. Using the remaining holes in the lower end of the
upper tube as a template, drill the 2 remaining
holes in the upper end of the lower discharge tube
(Figure
G. Remove the screw used to align the upper and
lower tubes.
9. Install the upper and lower discharge tubes as follows:
Note: Ensure that the mower deck is at the lowest
cutting position and the hopper bags are removed.
A. Insert the upper end (no holes) of the upper
discharge tube through the tube seal in the hood
by pushing the tube in until the tube contacts the
inside of the hood, then pull the tube out slightly
so that the seal extends outward
6
3
Upper Discharge Tube and Bagger Hood
1. Upper tube
2. Rubber seal protruding out
B. Align lower end of the lower discharge tube with
the blower-discharge port.
C. Align the notch in the lower discharge tube to
lower latch adjacent to the blower-discharge port.
D. Slip the discharge tube on the blower port and
attach the latches.
E. Slip the upper and lower discharge tubes together
(Figure
21
28).
1 2 3
G018440
Figure 29
3. Bagger hood
30).
(Figure 29).