Greasing The Idler Arm; Inspecting The Bagger; Inspecting The Mower Blades; Choosing The Mower Blades - Toro Z Master 2000 Series Operator's Manual

4. Remove the existing bagger belt from the mower-deck
pulley and then the blower pulleys.
5. Install the new belt around the blower pulleys and the
mower-deck pulley
6. Install the spring as shown in
1. Spring-loaded idler pulley
2. Short hook end
7. Pull back on the spring loaded idler pulley and install
the belt onto the spring loaded idler pulley

Greasing the Idler Arm

Service Interval: Every 50 hours
(Figure 39).
Figure 40.
Figure 40
3. Long hook end
(Figure
Figure 41

Inspecting the Bagger

Service Interval: Every 100 hours
After the first 8 hours
1. Disengage the PTO, move the motion control levers
to the N
brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Check the upper tube, lower tube, bagger hood, and
the blower assembly.
Note: Replace these parts if they are cracked or
broken.
4. Check the bags, bagger frame, and screen.
Note: Replace any parts that are cracked or broken.
5. Tighten all nuts bolts and screws.

Inspecting the Mower Blades

1. Inspect the mower blades regularly and whenever a
blade strikes a foreign object.
2. If blades are badly worn or damaged, install new blades.
Refer to your machine Operator's Manual for complete
blade maintenance.
39).

Choosing the Mower Blades

In most mowing conditions, the standard high lift blades will
provide the best bagging performance.
Use a Toro Atomic blade for bagging leaves in dry conditions.
In dry dusty conditions, the medium lift or low lift blades
will reduce dust and dirt blowout while providing effective
bagging air flow.
Contact an Authorized Service Dealer for the proper blades
for different mowing conditions.
Refer to the mower Operator's Manual for more information
on installing blades.

Replacing the Grass Deflector

WARNING
An uncovered discharge opening could allow
the lawn mower to throw objects toward you or
bystanders, resulting in serious injury. Also, contact
G018446
with the blade could occur.
• Never operate the lawn mower unless you install
a cover plate, a mulch plate, or a grass deflector
and a bagger.
• Ensure that the grass deflector is in the down
position.
30
locked position, and set the parking
EUTRAL