Storage - Toro Z Master 2000 Series Operator's Manual

1. Remove the locknut, bolt, spring, and
spacer that secure the grass deflector to
the pivot brackets on the deck
Remove the damaged or worn grass deflector.
6 2
1
g015594
Figure 42
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Place the spacer and spring onto the grass deflector.
Place 1 J-hook end of the spring behind the deck edge.
Note: Ensure that 1 J-hook end of the spring is
installed behind the deck edge before installing the bolt
shown in Figure 42.
3. Install the bolt and nut. Place 1 J-hook end of the
spring around the grass deflector
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates to the full down
position.
(Figure 42).
4
7
3
5
5. Spring installed
6. Grass Deflector
7. J- hook end of the spring
(Figure 42).

Storage

1. Clean the bagger attachment; refer to
Bagger and Bags (page
2. Inspect the bagger attachment for damage; refer to
Inspecting the Bagger (page
3. Ensure that the bags are empty and thoroughly dry.
4. Check the belt for wear or cracks.
5. Store the machine in a clean, dry place, out of direct
sunlight. If you must store the machine outside, cover
it with a weatherproof cover. This protects the plastic
parts and extends the life of the machine.
31
Cleaning the
29).
30).