Installing The Hood Baffle - Toro Z Master 2000 Series Operator's Manual

5. Slide the hopper-support frame to the left until the
mounting pin passes through the hole in the right
frame-support bracket
Note: The hopper-support frame and the
frame-support brackets are a close fit. If necessary,
use a soft-faced mallet to position the hopper-frame
support in the frame brackets.
6. Install the hairpin through the hole of the mounting
pin to secure the frame to the bracket
Install the hood rod as follows:
1. Align the hood rod so that the stop flange is toward the
hopper-support frame
4
Figure 12
Hood Rod Installation
1. Hood rod
2. Stop flange
2. Insert the rod through the hole in the hopper-support
frame until the stop flange is against the back side of
the frame (Figure 12).
Note: Ensure that the hole in the hood rod is
extending beyond the forward side of the hopper-frame
hole.
3. Secure the hood rod to the support frame by inserting
the hairpin through the hole in the hood rod
12).
(Figure 11).
(Figure 11).
(Figure 12).
3
2
1
g018360
3. Hopper-support frame
4. Hairpin
(Figure
7

Installing the Hood Baffle

Parts needed for this procedure:
1 Bagger hood
1 Baffle
2 Hairpin (small)
Install the Baffle in the Bagger Hood
1. Remove and retain the hairpins from the baffle.
2. Locate the baffle slots in the front and back side walls
of the bagger hood, and the mounting tabs on the
hood baffle (Figure
1
2
4
5
Hood, Baffle, and Hairpin
1. Hairpin
2. Bagger Hood
3. Baffle-mounting tab
3. Position the hood so that the duct seal is on your left,
as illustrated in
4. Align the baffle so that the screened area is up and
angled left (Figure
5. Insert the baffle up into the hood from the bottom
(Figure 13).
13
13).
3
Figure 13
4. Baffle slot
5. Baffle
6. Duct seal
Figure 13.
13).
6
G018355