Toro Z Master 2000 Series Operator's Manual page 10

i. Align the right flange of the exhaust
shield (the flange with 2 holes) to the
rear surface of the lower-left engine
guard (Figure
Figure 7
Heat Shield Installation on US Domestic Mower
ii. Align the bottom edge of the
exhaust-shield right flange to the
bottom edge of the engine guard
(Figure
iii. Align the left flange of the exhaust
shield (the flange with 1 hole) to the
surface of the small, angular area of
the lower-left engine guard.
Note: Ensure the left flange (the
flange with 1 hole) of the exhaust
shield is flush with the engine-guard
surface.
iv. Align the top edge of the
exhaust-shield left flange and
the top edge of the lower-left engine
guard so that the flange edge and the
guard edge are parallel
v. Mark the outline of all holes in the
exhaust-shield flanges on to the
lower-left engine guard, and remove
the exhaust shield from the engine
guard.
•
For International (TE) Mowers
i. Align the holes of the exhaust-shield
right flange (the flange with 2 holes)
7).
G018637
7).
(Figure
(Figure 7).
Heat Shield Installation on International (TE) Mower
1. Flange-hex-head bolt (3/8 x 1 inch) and Nut (3/8 inch)
iii. Loosely secure the right flange of the
7).
vi. Remove the fasteners and exhaust
3. Locate the center of the marks on the lower-left
engine-guard surface, and center-punch the locations.
4. Drill a 10 mm (3/8 inch) hole in the engine guard at
the center-punch mark created in step 3.
10
to the two left-most-vertical slots in
the lower-left engine guard
Figure 8
ii. Align the bottom edge of the right
flange of the of the exhaust shield to
the bottom edge of the engine guard
(Figure 8).
exhaust shield to the engine guard
with 2 flange-hex-head bolts (3/8 x 1
inch) and 2 flange nuts (3/8 inch).
iv. Align the left flange of the exhaust
shield (the flange with 1 hole) to
angular area of the lower-left engine
guard (Figure 8).
Note: Ensure that the left flange
(the flange with 1 hole) of the exhaust
shield is flush with the engine-guard
surface.
v. Mark the outline of the hole in the left
flange of the exhaust shield on to the
lower-left engine guard.
shield from the engine guard.
(Figure 8).
1
G018638