Installing Casters And Legs - Dean D20 Series Installation And Operation Manual

3.3 Installing Casters and Legs

A. Install casters and/or legs near where the fryer is to be used, as neither is secure for long
transit. Decathlon Series (CE) gas fryers cannot be curb mounted and must be equipped
with either legs or casters provided.
B. After unpacking, use a pallet or lift jack to raise the unit before installing the casters.
C. Align the caster or leg base holes with the leg support assembly and insert bolt. Install the
washers and nut hand tight, and repeat for all four holes in caster/leg base assembly.
D. Tighten the caster/leg against the leg support assembly by using appropriate tools. Ensure
that all four bolts are evenly tightened. Tighten the bolts to 5.65 Nm (50 inch-lbs.) torque.
E. For fryers with casters, there are no built-in leveling devices. The floor where the fryers
are installed must be level.
Front Channel
or Rear Channel
Front or Rear Leg with
Mounting Plate
Adjust as needed
DECATHLON SERIES GAS FRYERS (CE)
CHAPTER 3: INSTALLATION
1/4-20 x 3/4 Hex Bolt
Front Channel or
Rear Channel
Leg Support Assembly
Washer
1/4-20 Hex Head Locknut
1/4-20 x 3/4 Hex Bolt
3-2