Rider's Seat - Triumph Tiger 1200 GT 2021 Owner's Handbook Manual

Rider's Seat

Warning
The rider's seat is only correctly
retained and supported once the
passenger seat is correctly installed.
Never ride the motorcycle with the
passenger seat detached or removed,
as the rider's seat will not be secure
and may move.
A loose or detached seat may cause
loss of motorcycle control and an
accident.
Rider's Seat Removal
1. Rider's seat release mechanism
To remove the rider's seat:
▼ Remove the passenger's seat (see
page 90).
▼ If
equipped with
disconnect the
electrical connector for complete
removal from the motorcycle.
▼ Push
the rider's
mechanism towards the front of
the motorcycle. This will release the
rider's seat from its lock.
▼ Grasp the rider's seat on either side,
and slide it rearwards and upwards.
1
heated seats,
heated seat's
seat release
GENERAL INFORMATION
Rider's Seat Installation
1
2
1. Rider seat rear bar
2. Rear seat hooks
3. Seat bridge
4. Rider seat front bar
To install the seat:
▼ If equipped, connect the heated
seat's electrical connector.
▼ Line up the rider seat front bar with
the seat bridge and slide forwards
and down to engage fully with the
hooks on the seat bridge.
▼ At the same time, lower the rear of
the rider seat and engage the rider
seat rear bar into the rear seat
hooks.
▼ Push forwards and press down
firmly on the rear of the seat to
engage the seat lock.
▼ Reinstall the passenger seat (see
page 90).
4
3
91