Daytime Running Light (Drl) (If Equipped); Bend Lighting (If Equipped) - Triumph Tiger 1200 GT 2021 Owner's Handbook Manual

Caution
Do not cover the headlight or lens with
any item likely to obstruct air flow to,
or prevent heat escaping from, the
headlight lens.
Covering the headlight lens during
operation with items
luggage, adhesive
intended to alter
headlight beam
headlight lens covers will cause the
headlight lens to overheat and distort,
causing irreparable damage to the
headlight assembly.
Damage caused by overheating is
not considered
defect and will not be covered under
warranty.
If the headlight must be covered
during use - such as taping of
the headlight lens required during
closed-course conditions
headlight must be disconnected.
Caution
If a fault occurs with the headlight
unit, then a message will be shown
in the instrument display and the
headlight will only be available in the
dipped beam mode.
Contact an authorized Triumph dealer
as soon as possible to have the fault
checked and rectified.
of clothing,
tape, devices
or adjust the
or non genuine
a manufacturing
- the
MAINTENANCE
Daytime Running Light (DRL)
(if equipped)
The Daytime Running Light (DRL) is
situated within the headlight assembly
and is a sealed, maintenance free
LED unit. The headlight unit must be
replaced in the event of the failure of
the DRL.

Bend Lighting (if equipped)

Bend lighting provides additional LED
lighting for left and right turns when
riding the motorcycle. It compensates
for the bank angle of the motorcycle
when cornering in dip beam mode.
The bend lights are switched on and off
automatically as the motorcycle leans
through corners. The left hand and
right hand bend light comprises of four
separate lights which switch on and
increase in brightness depending on the
lean angle of the motorcycle. When the
motorcycle is stationary, no bend lights
are on.
163