Triumph Tiger 1200 GT 2021 Owner's Handbook Manual page 36

GENERAL INFORMATION
36
If traction control is switched off:
▼ The TC indicator light will not
illuminate. Instead the TC disabled
warning light will be illuminated.
Traction Control (TC) Disabled
Warning Light
The TC disabled warning light
should not illuminate unless
traction control is switched
off or there is a malfunction.
If the warning
illuminated while riding, it indicates
that the traction control system has a
malfunction that requires investigation.
Blind Spot Radar Status Light
The blind spot radar status
light works with the blind spot
radar system, see page 73.
The blind spot radar status
light illuminates green when the blind
spot radar is enabled and active.
The blind
illuminates amber when the blind spot
radar is disabled and not active.
The blind spot radar status light also
illuminates amber when there is a fault
with the blind spot radar and a message
will be shown in the instrument display.
The left and right blind spot radar
indicator lights will also be illuminated at
the same time and stay on.
Turn Signals
When the turn signal switch is
turned to the left or right, the
indicator warning light will
flash on and off at the same
speed as the turn signals.
light becomes
spot radar status
Hazard Warning Lights
To turn the hazard warning lights on
or off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched OFF, until the
hazard warning light switch is pressed
again.
High Beam Light
When the high beam button is
pressed the high beam will be
switched on. Each press of
the button will swap between
dip and high beam.
If daytime running lights are installed on
the motorcycle, the high beam button
has additional functionality.
If the DRL switch is in the daytime
running lights position, then press and
hold the high beam button to turn the
high beam on. It will remain on as long
light
as the button is held in and will turn off
as soon as the button is released.
A lighting on/off switch is not installed
on this model. The tail light and license
plate light all function automatically
when the ignition is on.
The headlight will function when the
ignition is on. The headlight will go off
while pressing the starter button until
the engine starts.