Western Digital OpenFlex F3 Series Instruction Manual page 55

1. EU EcoDesign Compliance
EcoDesign Disclosures
1.6 Chassis Disassembly
Note: The screw that attached in the single screw cutout is difficult to get
to due to the backflow preventer. You may need to push the backflow
preventer to the side from the rectangular cutout.
c. From the rear of the chassis, remove the 2 T7 screws from the bottom PSU enclosure.
Figure 54: PSU Enclosure Rear Screws
d. Slide the PSU enclosure toward the rear of the chassis and pull it up and out of the
chassis.
52