Western Digital OpenFlex F3 Series Instruction Manual page 39

EcoDesign Disclosures
b. Lower the release handle until the BMC module is fully unseated (this occurs at about 60°)
and pull the BMC module out of the chassis ensuring that you support the under side of
the BMC module with your other hand.
Step 2 : Uninstall the BMC top cover.
a. Remove the 3 T7 screws from either side of the top cover (six total) using a T7 Torx
screwdriver.
Figure 29: BMC Module Release Handle Operation
Figure 30: Uninstall BMC Module
1. EU EcoDesign Compliance
1.5 BMC Module Disassembly
36