Western Digital OpenFlex F3 Series Instruction Manual page 50

EcoDesign Disclosures
Step 7 : Uninstall the remaining devices from the chassis.
Step 8 : Uninstall the top rear chassis cover.
a. Remove the T7 screw from either side of the rear top cover (two total) using a T7 Torx
screwdriver.
b. Remove the 4 T7 screw from the rear top cover using a T7 Torx screwdriver.
Figure 46: Rear Chassis Cover Screws (Sides)
Note: Right Side pictured. The left side is not displayed, but the location
of the screw is in the same place on the left side.
1. EU EcoDesign Compliance
1.6 Chassis Disassembly
47