Western Digital OpenFlex F3 Series Instruction Manual page 33

EcoDesign Disclosures
d. Remove the transceiver connector from the rear of the NIC by pulling on the tab and
sliding the transceiver out of the NIC connector.
e. Slide the NIC up and out of the connector by pulling up on the tab in the left-hand corner
and the connector on the top right corner of the NIC.
Step 7 : Uninstall the Interposer.
a. Remove the 5 remaining T10 screws from the interposer using the T10 Torx screw.
Figure 21: Removing the NIC
1. EU EcoDesign Compliance
1.4 OpenFlex F3x00 Disassembly
30