Maxi-Cosi MAGELLAN XP MAX Manual page 29

51
10
Attach Lower Anchor
Connector to Vehicle's Lower
Anchor
Review your vehicle owner's manual
for lower anchor locations and lower
anchor belt use.
Make sure arrows on
connectors are facing up.
Fasten one lower anchor belt
connector to the anchor located in
the vehicle seat bight.
Repeat for other side of child
restraint.
11
Tighten Belt
Place hand in child restraint. Firmly push child restraint down
while pulling the free end of the belt parallel with the belt path
through the belt path opening as shown.
12 Tighten Tether
Push fi rmly on the back of the seat
and pull the tether strap to remove
all slack and create tension on the
strap.
13
Check Belt Tightness
Hold child restraint at the belt path
with your weaker hand.
Push and pull from side to side. It
should not move more than 1 in. (2.5
cm).
If it moves more than 1 in. 2.5 cm, you can try:
A. Putting your knee in the car seat and pulling the belt tighter.
B. Reinstalling the child restraint.
C. Changing to a different seating location.
D. Switching to vehicle belt installation.
14
Replace Headrest Pad
Fasten all the headrest pad fasteners. Adjust the headrest/
harness back to the correct position for your child. See page 9.
Finished!
Check the tightness of the install often to
make sure it has not loosened.
Securing Child in Car Seat
To properly secure your child in the car seat,
see pages 53-55. Check your child's fi t often
and make any needed adjustments to the car
seat as they grow.
52