Extron electronics FOX 4G Matrix 14400 Setup Manual page 12

Command
Create ties
N • Commands can be entered back-to-back in a string, with no spaces. For example: 1*1!02*02&003*003%.
• The matrix switchers support 1-, 2-, and 3-digit numeric entries (1*1!, 02*02&, or 003*003%).
N The & tie command for RGB and the % tie command for video can be used interchangeably.
N The & read tie command for RGB and the % read tie command for video can be used interchangeably.
X! X@
to output video
Tie input ,
and audio
Example:
X! X@
to output , RGBHV
Tie input
only
Example:
(see 2nd Note, above)
X! X@
to output , video
Tie input
only
Example:
(see 2nd Note, above)
Read RGB output tie
Read video output tie
X!
= Input number
N
X@
= Output number
Command
Channel mute commands
Channel mute
Channel unmute
Read channel mute
Global channel mute
Global channel unmute
View output mutes
Save and recall presets
N If you try to recall a preset that is not saved, the matrix switcher responds with the error code E11.
Save current configuration as a
global preset
Example:
Recall a global preset
Example:
X@
= Output number
N
X#
= Mute
X$
= Global or room preset #
ASCII command Response
(host to switcher) (switcher to host)
X! X@
* ! Out
1*3!
Out03
X! X@
* & Out
10*4&
Out04
X! X@
* % Out
7*5%
Out05
X@ X!]
&
X@ X!]
%
00 – (maximum number of inputs for your configuration) (00 = untied)
01 – (maximum number of outputs for your configuration)
ASCII command Response
(host to switcher) (switcher to host)
X@
*1B Vmt
X@
*0B Vmt
X@ X#]
B
1*B
Vmt1
0*B
Vmt0
E } X#
1
VM
X$ ,
Spr
,
Spr09
9
X$ .
Rpr
.
Rpr05
5
01 – (maximum number of inputs for your model)
0 = not muted, 1 = muted
0 - 64
Additional description
X@ X! ]
• In • All Tie input
X@
.
]
Tie input 1 video and audio to output 3.
• In01 • All
X@ X! ]
Audio breakaway.
• In • RGB
]
Tie input 10 RGB to output 4.
• In10 • RGB
X@ X! ]
Audio breakaway.
• In • Vid
]
Tie input 7 video to output 5.
• In07 • Vid
RGBHV input
Video input
Additional description
X@ ]
*1 Mute output
the light output remains active).
X@ ]
*0 Unmute output
1 = mute on, 0 = mute off.
]
Mute all light outputs.
]
Unmute all light outputs.
X# X# ]
2 n
, , ... Each
output, starting from output 1.
n = the maximum number of outputs for
your configuration.
X$]
Command character is a comma.
]
Save current ties as preset 9.
X$]
Command character is a period.
]
Recall preset 5, which becomes the current
configuration.
X!
's video and audio to output
X! X@
is tied to output
X! X@
is tied to output .
X@
(no signal is output, but
X@
(signal is output).
X#
response is the mute status of an
.