Rack Mounting Procedures - Extron electronics VGA Distribution Amplifiers P/2 DA12 Series User Manual

Extron electronics p/2 da8 and p/2 da12 series vga distribution amplifiers user's manual

Hide thumbs Also See for VGA Distribution Amplifiers P/2 DA12 Series:

Table of Contents

overloading might have on overcurrent protection and

supply wiring. Give appropriate consideration to the

equipment nameplate ratings when addressing this

concern.

Reliable earthing (grounding) — Maintain reliable

grounding of rack-mounted equipment. Pay particular

attention to supply connections other than direct

connections to the branch circuit (such as the use of power

strips).

Rack mounting procedures

The units can be rack mounted, using the MBD 149 mounting kit

(part #70-077-03) provided with the unit.

Remove rubber feet if these have been installed on the

bottom of the unit.

Secure one bracket to each side of the distribution amplifier

with the provided bracket mounting screws (four #8 screws

for each bracket — see figure 1 below).

Bracket mounting screws

Figure 2-1 — Installing a full rack unit on a shelf rack

Align the holes in the mounting brackets with holes in the

rack and secure the unit with brackets to the rack using the

four rack-mounting screws and four washers provided with

the mounting kit.

P/2 DA8 and P/2 DA12 • Installation and Operation

MBD 149 Bracket

FRONT

Rack mounting screws

2-3

Table of Contents

P/2 da8 P/2 da8 a P/2 da12 a