Video Input And Output Connections - Extron electronics VGA Distribution Amplifiers P/2 DA12 Series User Manual

Video Input and Output Connections

All models are able to accept RGBHV, RGBS, RGsB, RsGsBs,
YUV (tri-level and bi-level sync), S-video and composite video,
and resolutions from VGA (640 x 480) to QXGA (2048 x 1536).
The signal is distributed without modification: the output
format follows the input format.
To make input and output connections with other devices,
follow these instructions:
1. Turn off the power to the distribution amplifier and the
video source.
2. Connect the video source to the 15-pin female HD input
socket on the rear panel of the distribution amplifier.
3. Connect the display devices to the 15-pin female HD
output sockets on the rear panel of the distribution
amplifier.
N
N
N
15-pin HD Connector
Figure 2-5 — Video Connections
P/2 DA8 and P/2 DA12 • Installation and Operation
ID bits on pins 4, 11, 12, and 15 are routed to Output 1.
For optimal performance, all display devices should have
similar resolution capabilities.
For sources and displays that require different
connectors, use an HD adapter cable, such as the Extron
SY BNCM series (#26-533-xx; see the figure below, at
left). The BNC connectors used for different signal types
are shown in the figure below, at right.
RGBHV
RGBS
RGsB,
RsGsBs,
Component
S-video
Composite
R G B
B
R G
G
R B
R G B
G B
R
V
H
H
V
V
H
V
H
H
V
2-9