B2 Intended Use - Bicker UPS-1000-B1 User Manual

UPS-1000-B1

B2 Intended use

• The UPS is designed for the 230 V mains.
• The UPS-1000-B1 may only be installed in an upright position.
• Never install the UPS near liquids or in an excessively humid environment.
• Do not expose the UPS to direct sunlight or a heat source.
• After the initial installation to the AC mains, the battery starts to charge.
• It takes about 8 hours to fully charge.
• To minimize battery damage, the UPS has to be charged before storage and recharged every 6 months.
• The UPS must not be used as an inverter for any purpose other than that for which it was intended.
• The UPS is not designed for medical or life support systems.
• No laser printer or tube monitor may be connected to the UPS.
• It must be ensured that no foreign matter enters the UPS and that the fan outlet is always free.
• It must be ensured that the UPS-1000-B1 may only be loaded with maximum load. This value can be found
in the technical data in chapter A.
9
Revision 1