Table of Contents
Advertisement
UPS-1000-B1
B Introduction and description
Read carefully before initial operation !
This manual shall help the user to get familiar with the product and its components and features. It shall
provide information as accurately and completely as possible.
The manual as well as all documents has to be read and followed strictly before installation. Otherwise in
certain situations warranty and guarantee can be cancelled partly or completely. Any liability on the part of
Bicker Elektronik is excluded for possible existing errors as well as non-compliance with the instructions for
use and installation.
B1 Description of the product and its functions
The UPS-1000-B1 is a uninterruptible Power Supply (UPS) with Line Interactive Design. In contrast to a con-
ventional off-line UPS, it has a sine voltage output. The UPS can be operated with a BP-2480 battery pack up
to +60 °C operating temperature.
The primary use of the UPS is to supply the connected application during power failures and / or voltage fluc-
tuations. The application which should be protected is connected to the output of the UPS.
In the event of a voltage drop or a voltage fluctuation of the input voltage (below undervoltage limit), the UPS
is switched to battery mode (also backup mode). In this state, the application at the UPS output is supplied via
the inside energy storage device. The backup time (also buffer time) depends on the available energy of the
installed battery pack, the level of the connected load current and the software settings of the UPS.
In the event of a power failure and the set backup time in UPSilon2000 has expired, the operating system of
the PC is shut down and the UPS is switched off.
In the event of a power failure and the return of the input voltage during the shutdown of the operating
system, the operating system is shut down by the UPS management software UPSilon2000. The UPS then
switches off the output for a short time. After a few seconds, this reboot function automatically switches back
to mains operation. The downstream PC can then automatically start here (BIOS setting PC). In addition, the
energy storages are recharged.
8
Revision 1
Advertisement
Table of Contents
