Table of Contents
Advertisement
UPS-1000-B1
G Operation
G1 UPS on
The UPS-1000-B1 is connected to the mains. The internal battery is being charged.
2.1 LCD-Anzeige und Bedienelemente
The internal battery is being charged. The battery level is displayed.
If the automatic switch-on function is activated, the UPS switches on and activates the mains output sockets.
POWER ON/OFF Ein/Aus Taster
1
The current input voltage can be seen in the display. If the automatic switch-on function is deactivated, the
SELF TEST Selbsttest
Power ON / OFF button (1) must be pressed to switch on.
ALARM RESET Alarm aus
2
LCD-Anzeige.
SELECT Auswahltasten für Modi und Einstellungen
3
G2 UPS off
If the Power ON / OFF button (1) is pressed for 4 seconds, the UPS switches off the mains output sockets and
the UPS switches off after approx. 10 seconds. „oFF" appears in the display. The battery is charged even when
the UPS is switched off.
G3 Cold start
The UPS can be switched on without a mains input. To do this, the Power ON / OFF button (1) has to be pressed
for one second. „oFF" appears in the display. Then press the Power ON / OFF button (1) again!
G4 „oFF" mode
In „oFF" mode, the UPS switches off within 10 seconds in the event of a power failure.
In „oFF" mode, the UPS switches itself off within 10 seconds when the mains cable is disconnected.
G5 SELF test button (1)
For a battery load test, the mains lead can be disconnected for a mains failure simulation. However, if the SELF
test button (1) is pressed instead of unplugging the mains lead, the UPS switches off the mains internally for
10 seconds for a load test.
The application or e.g. a 100 W incandescent lamp can be used as load. To cancel the self-test, the SELF test
button (1) can be pressed for 2 seconds.
Revision 1
5
16
Advertisement
Table of Contents
