Advertisement
Available languages
Available languages
22
[12] Install WIRE HARNESS
1. Install STAY BASE to MAIN FRAME with FLANGE
BOLTs. (Fig.47 (6))
[Tightening torque: 23.5 to 27.5 N-m (2.4 to 2.8 kgf-m)]
2. Install FUSE BOX STAY 2 to STAY BASE with
FLANGE BOLTs. (7) Do not tighten bolts.
3. Set STAY SUPPORT to MAIN FRAME. And install It
to FUSE BOX STAY 2, then tighten four BOLTs. ((5),
(7))
[Tightening torque: 23.5 to 27.5 N-m (2.4 to 2.8 kgf-m)]
(1) STAY BASE <49>
(2) MAIN FRAME
(3) FUSE BOX STAY 2 <50>
(4) STAY SUPPORT <52>
(5) BOLT (WITH LOCK AND PLAIN WASHER) <56> x 2
(6) FLANGE BOLT <53> x 2
(7) FLANGE BOLT <53> x 2
4. Install CA RELAY to FUSE BOX STAY 2 with
TAPPING SCREW. (Fig.48)
[Tightening torque: 9.8 to 11.3 N-m (1.0 to 1.2 kgf-m)]
5. Connect SERVICE WIRE HARNESS ASSY T2 to CA
RELAY and set CLIP on STAY BASE.
(1) CA RELAY <54>
(2) TAPPING SCREW <55>
(3) SERVICE WIRE HARNESS ASSY T2 <62>
(4) CLIP
6. Install CLAMP STAY to MAIN FRAME with SCREW
(WITH LOCK WASHER). (Fig.49)
[Tightening torque: 9.8 to 11.3 N-m (1.0 to 1.2 kgf-m)]
7. Connect SERVICE WIRE HARNESS ASSY T2 to
TEMP. SWITCH and set CLIP on STAY BASE.
(1) CLAMP STAY <57>
(2) CLIP
(3) SCREW (WITH LOCK WASHER) (M4) <58>
(4) TEMP. SWITCH <19>
(5) MAIN FRAME
Advertisement
