Mounting Into The Case; Bolt Down The Pc Board; Add Front Panel Hardware; Figure 101. Mount All Four Corners Of The Main Board Using The Mounting Hardware As Shown - NORCAL NC2030 Manual

Mounting into the case

Bolt down the PC board

Transmitter section to the rear side of the case, headphone outputs to the front.

Figure 101. Mount all four corners of the main board using the mounting hardware as shown.

Be very careful when mounting the screws on the particular corner shown above. There is one
surface mount cap that is very close to the nut on the top side of the board. Don't knock it off!

Add front panel hardware

Figure 102. NC2030 with all front panel hardware mounted in prototype chassis. Case will be silk screened.
Lots of pictures in this section! Here we will mount the hardware to the front panel.
Norcal NC2030 v5 12-18-05
Page 85 of 128