Figure 71. Mcdonald's Straw Diameter; Figure 72. Main Tuning Pto Coil L13 Shown Mounted To The Front Panel. This Is Used Only When The Rig - NORCAL NC2030 Manual

Figure 71. McDonald's straw diameter.

Remove the temporary 100 ohm load resistor from the output of the switching supply. At this point
the board draws enough current to have proper switching supply regulation.
Figure 72. Main tuning PTO coil L13 shown mounted to the front panel. This is used only when the rig is finished.
While we are at this point, we might as well take some time to start work on the real L13 PTO coil as
this will take some time (epoxy glue is involved) can be done in the background.
L13 - PTO coil 105T # 30 on Kevlar Coil Form
Norcal NC2030 v5 12-18-05
Page 63 of 128