Afa Rf Buffer And Phase Splitter; Figure 61. General Location Of The Afa Rf Buffer And Phase Splitter; Figure 62. Close Up View Of The Afa Rf Buffer And Phase Splitter Area - NORCAL NC2030 Manual

Low power, high performance 20m or 30m dc transceiver
Table of Contents

Advertisement

AFA RF Buffer and Phase Splitter

Figure 61. General location of the AFA RF Buffer and Phase Splitter

Figure 62. Close up view of the AFA RF Buffer and Phase Splitter Area

This next section skips over a few other sections primarily so that we can get the analog to digital
squaring section for the AFA frequency counter in place so that we can temporary connections between
this buffer and the VXO so that we can test the VXO that was just finished. The RF phasing section
contains parts that are band specific.
The RF phase splitter will not be aligned until much later in the receiver section when alignment is
performed to null out the opposite sideband.
Install the parts in this section in the following order:
U9 - 74AHC00D -
- Caution! Double check installation polarity as shown below!
Norcal NC2030 v5
12-18-05
Page 55 of 128

Advertisement

Table of Contents
loading

Related Products for NORCAL NC2030

Table of Contents