Figure 5. Parts In Bag Pockets Are Accessed Via Slit Cut Into The Packet Just Larger Enough To Get The Part; Figure 6. Close Up Of A Surface Mount Parts Strip And The Bag Slit Just Large Enough To Access The Strip - NORCAL NC2030 Manual

Figure 5. Parts in bag pockets are accessed via slit cut into the packet just larger enough to get the part out.

Figure 6. Close up of a surface mount parts strip and the bag slit just large enough to access the strip.

Below is an example of a bag layout as compared to a real bag. Notice the correspondence of the three
single resistor pockets at the top of the real bag compared to the bag layout.
Norcal NC2030 v5 12-18-05
Page 15 of 128