Manually Recording A Digital Source - Pioneer Elite PRB-19RW Operating Instructions Manual

Manually Recording a Digital Source

If you are recording from a digital source other than
not possible since there are no track numbers or start
sources, use the manual recording method described here.
1 3 2
Hi-bit Legato Link Conversion
5 7
, ,
CD MD DCC
s to signal the start and end points of the recording. For these
ID
1
Load a CD–R or CD–RW disc.
Check the display to make sure that there's enough space on the disc
for what you want to record.
2
Set the INPUT SELECTOR to either COAXIAL or
OPTICAL.
Set to whichever input your source is connected to.
3
Press RECORD ¶ ( ¶ REC on the remote control).
If you're using the remote, press both ¶
The recorder goes into record-pause mode.
4
Start playing the source to check it's recordable.
3
If the recorder does not recognize the digital format, or the source is
copy-protected using
appears. In either case, you won't be able to record digitally—use the
5
analog inputs instead (see the following page).
If the signal appears
7
5
Check that the time display reads 00:00, then press
8 (pause) or 3 (play) to start recording.
6
Restart playback of the source material.
If the
AUTO TRACK
a new track each time it encounters two seconds of continuous silence.
(To switch off auto track numbering see page 28.)
7
When you're done, press 7 (stop).
After pressing 7 (stop), the display shows
❖
the track information to the disc.
Basic Playback and Recording
or —digital satellite, for example — synchro recording is
DAT
REC
, the message
SCMS CAN NOT REC
, stop the source.
OK
indicator is lit in the display then the recorder will start
buttons simultaneously.
or
CAN NOT COPY
while it records
PMA REC
<PRB1286>
23