Table of Contents
Advertisement
Setup
3. Setup
AC Power
AC Plug
DMX Linking
DMX Modes
Master/Slave
Connectivity
-6-
Each COLORado™ Deco Quad 1 Tour has an auto-ranging power supply that works
with an input voltage range of 100~240 VAC, 50/60 Hz. To determine the power
requirements for each COLORado™ Deco Quad 1 Tour, refer to the label affixed to the
product. You can also refer to the
The listed current rating indicates the maximum current draw during normal operation.
For more information, you may download Sizing Circuit Breakers from the CHAUVET®
website: www.chauvetpro.com.
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
The COLORado™ Deco Quad 1 Tour comes with a power input cord terminated with a
proprietary connector on one end and an Edison plug on the other end (U.S. market). If
the power input cord that came with your product has no plug, or if you need to change
the Edison plug, use the table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
You can link the COLORado™ Deco Quad 1 Tour to a DMX controller using a standard
DMX serial connection. If using other DMX compatible products with the COLORado™
Deco Quad 1 Tour, you can control each individually with a single DMX controller.
The COLORado™ Deco Quad 1 Tour uses the standard DMX data connection for tor,
A1, A1.d, A2, A2.d, A2.S, and hSU DMX modes.
• Refer to the
Introduction
• Refer to the
Operation
Quad 1 Tour to work in these modes.
• The
DMX Values
section will provide you with detailed information regarding the DMX
modes.
The Master/Slave mode allows a COLORado™ Deco Quad 1 Tour (the "master
product") to control one or more COLORado™ Deco Quad 1 Tours (the "slave products")
without a DMX controller. One COLORado™ Deco Quad 1 Tour becomes the master
product when running an Auto or Custom program, or by being in STA mode.
You must configure each slave product's control panel to operate in SLA mode. During
Master/Slave operation, the slave products will operate in unison with the master
product.
DO NOT connect a DMX controller to products operating in Master/Slave mode.
The DMX controller signals may interfere with the signals from the master
product.
The
Operation
chapter of this manual provides detailed instructions on how to
configure the Master and Slave products.
If you are not familiar with or need more information about DMX standards,
Master/Slave connectivity, or the DMX cables needed to link this product to a DMX
controller,
download
www.chauvetpro.com.
Technical Specifications
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Green/Yellow
chapter for a brief description of these modes.
chapter to learn how to configure the COLORado™ Deco
the
DMX
Primer
COLORado™ Deco Quad 1 Tour User Manual Rev. 1
chart in this manual.
Screw Color
Brown
Yellow or Brass
Blue
from
the
CHAUVET®
Silver
Green
website
Advertisement
Table of Contents
