Table of Contents
Advertisement
DMX Linking
DMX
Personalities
Master/Slave
Connectivity
COLORdash™ Accent User Manual Rev. 5
You can link the COLORdash™ Accent to a DMX controller using a 3-pin DMX connection. If
using other DMX-compatible products with the COLORdash™ Accent, you can control each
individually with a single DMX controller.
The COLORdash™ Accent uses a 3-pin DMX data connection for the STAGE1, ARC.1, and
ARC.2 DMX personalities.
·
Refer to the
Introduction
·
Refer to the
Operation
in these personalities.
·
The
DMX Values
section provides you with detailed information regarding the DMX
personalities.
If you are not familiar with or need more information about DMX standards, Master/Slave
connectivity, or the DMX cables needed to link this product to a DMX controller, download
the DMX Primer from the CHAUVET® website: www.chauvetlighting.com/download/pro.
The Master/Slave mode allows a COLORdash™ Accent (the master) to control one or more
COLORdash™ Accents (the slaves) without a DMX controller. One COLORdash™ Accent
becomes the master when running an auto program, or by being in a Static mode.
You must configure each slave's control panel to operate in Slave mode. During Master/Slave
operation, the slaves will operate in unison with the master.
DO NOT connect a DMX controller to products operating in Master/Slave mode. The DMX
controller signals may interfere with the signals from the master.
The
Operation
section of this manual provides detailed instructions on how to configure
the master and slaves.
chapter for a brief description of each DMX personality.
chapter to learn how to configure the COLORdash™ Accent to work
Setup
-7-
Advertisement
Table of Contents
