Table of Contents
Advertisement
Setup
3. S
ETUP
AC Power
AC Plug
DMX Linking
DMX
Personalities
Master/Slave
Connectivity
-6-
Each COLORdash™ Accent Quad has an auto-ranging power supply that works with an input
voltage range of 100 to 240 VAC, 50/60 Hz. To determine the power requirements for each
COLORdash™ Accent Quad, refer to the label affixed to the product. You can also refer to the
Technical Specifications
The listed current rating indicates the maximum current draw during normal operation. For more
information, you may download Sizing Circuit Breakers from the Chauvet website:
www.chauvetprofessional.com.
·
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
·
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
The COLORdash™ Accent Quad comes with a power input cord terminated with an Edison
plug (US market). If the power cord that came with your fixture has no plug or you need to
change the Edison plug, use the table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
You can link the COLORdash™ Accent Quad to a DMX controller using a 5-pin DMX
connection. If using other DMX-compatible products with the COLORdash™ Accent Quad, you
can control each individually with a single DMX controller.
The COLORdash™ Accent Quad uses a 5-pin DMX data connection for the 4-, 6- and 10-
channel DMX personalities.
·
Refer to the
Introduction
·
Refer to the
Operation
work in these personalities.
·
The
DMX Values
section provides you with detailed information regarding the DMX
personalities.
If you are not familiar with or need more information about DMX standards, Master/Slave
connectivity, or the DMX cables needed to link this product to a DMX controller,
download the DMX Primer from the Chauvet website: www.chauvetprofessional.com.
The Master/Slave mode allows a COLORdash™ Accent Quad (the master) to control one or
more COLORdash™ Accent Quads (the slaves) without a DMX controller. One COLORdash™
Accent Quad becomes the master when running an auto or custom program, or by being in a
Static mode.
You must configure each slave's control panel to operate in Slave mode. During Master/Slave
operation, the slaves will operate in unison with the master.
DO NOT connect a DMX controller to products operating in Master/Slave mode. The DMX
controller signals may interfere with the signals from the master.
The
Operation
section of this manual provides detailed instructions on how to configure
the master and slaves.
If you are not familiar with or need more information about DMX standards, or the DMX
cables needed to link this product to a DMX controller, download the DMX Primer from
the Chauvet website: www.chauvetprofessional.com.
chart in this manual.
Wire (U.S.)
Black
White
Green/Yellow
chapter for a brief description of each DMX personality.
chapter to learn how to configure the COLORdash™ Accent Quad to
Wire (Europe)
Brown
Yellow or Brass
Blue
Green/Yellow
COLORdash™ Accent Quad User Manual Rev. 2
Screw Color
Silver
Green
Advertisement
Table of Contents
