Setup; Ac Power; Ac Plug; Power Linking - Chauvet ColorAdo 1-Quad Zoom Tour User Manual

Setup

3. S
ETUP

AC Power

AC Plug

Power Linking

DMX Linking

DMX
Personalities
Master/Slave
Connectivity
-6-
Each Colorado™ 1-Quad Zoom Tour has an auto-ranging power supply that works with an input
voltage range of 100 to 240 VAC, 50/60 Hz. To determine the power requirements for each
Colorado™ 1-Quad Zoom Tour, refer to the label affixed to the product. You can also refer to
the Technical Specifications
The listed current rating indicates the maximum current draw during normal operation. For more
information, you may download Sizing Circuit Breakers from the Chauvet website:
http://www.chauvetlighting.com/download/.
Always connect this product to a protected circuit with an appropriate electrical ground
to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
The Colorado™ 1-Quad Zoom Tour comes with a power input cord terminated with a Neutrik®
powerCON® A connector on one end and an Edison plug on the other end (U.S. market). If the
power input cord that came with your product has no plug, or if you need to change the Edison
plug, use the table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
The Colorado™ 1-Quad Zoom Tour supports power linking. You can power link up to
12 products at 120 V; up to 21 at 208 V; or up to 23 at 230 V. This product comes with a power
input cord. Power linking cables are available from Chauvet for purchase.
You can link the Colorado™ 1-Quad Zoom Tour to a DMX controller using a 3- or 5-pin DMX
connection. If using other DMX-compatible products with the Colorado™ 1-Quad Zoom Tour,
you can control each individually with a single DMX controller.
The Colorado™ 1-Quad Zoom Tour uses a 3- or 5-pin DMX data connection for its 3, 4, 5, 6, 7,
10, 12, 17, or 25-channel DMX personalities.
·
Refer to the Introduction
·
Refer to the Operation
to work in these personalities.
·
The DMX Values section provides you with detailed information regarding the DMX
personalities.
If you are not familiar with or need more information about DMX standards,
Master/Slave connectivity, or the DMX cables needed to link this product to a DMX
controller, download
http://www.chauvetlighting.com/download/.
The Master/Slave mode allows a Colorado™ 1-Quad Zoom Tour (the master) to control one or
more Colorado™ 1-Quad Zoom Tours (the slaves) without a DMX controller. One Colorado™ 1-
Quad Zoom Tour becomes the master when running an auto or custom program, or by being in
a Static mode.
You must configure each slave's control panel to operate in Slave mode. During Master/Slave
operation, the slaves will operate in unison with the master.
DO NOT connect a DMX controller to products operating in Master/Slave mode. The DMX
controller signals may interfere with the signals from the master.
The Operation section of this manual provides detailed instructions on how to configure
the master and slaves.
chart in this manual.
Wire (U.S.)
Black
White
Green/Yellow
chapter for a brief description of each DMX personality.
chapter to learn how to configure the Colorado™ 1-Quad Zoom Tour
the DMX Primer
Wire (Europe)
Brown Yellow or Brass
Blue
Green/Yellow
from the Chauvet
Colorado™ 1-Quad Zoom Tour User Manual Rev. 1
Screw Color
Silver
Green
website: