Table of Contents
Advertisement
Auto-negotiation allows the switch and the connected device to determine the fastest mutually supported connection
speed. However, there are some situations where, due to poor cabling, interference or traffic congestion, ability to force the
connection to a particular speed is desirable.
Range is from 10Mb – Half Duplex (a common value for older devices) to 1Gb – Full Duplex. The port may also be disabled.
NOTE: It is not possible to force a device to connect at a speed faster than the device's network interface hardware will
support.
BANDWIDTH USE
Shows bandwidth used on the selected port as a percentage value. Bandwidth is relative to the port speed as negotiated
by the link partner, i.e. if the port is set to 100Mbit, a bandwidth use of 55% is equal to approximately 55Mbit of traffic per
second.
This menu item is read-only.
CURRENT MULTICAST GROUPS
Displays a list of the multicast addresses used by the end device connected to the selected port.
It is not possible to block a specific multicast group. The menu list is read-only.
PORT 13 & 14: CONFIGURATION/STATUS: SFP+ PORTS
Ports 13 and 14 are SFP+ ports. These behave the in the same manner as ports 1-12 for configuration from the front UI
menu, however have slightly different menu items.
July 2021
Port <x> Configuration
SFP Module: 10GBase-SR
Link Mode: 10G Full Duplex
VLAN: Untagged (Normal)
VLAN ID: <x>
Bandwidth Use: 1%
Current Multicast Groups
<Back>
PWVIA RM P12 Ethernet Switches - Manual
79
Advertisement
Table of Contents
