Table of Contents
Advertisement
FACTORY DEFAULT
In the event of a loss of communication with the device (e.g. Management VLAN accidentally set to a value outside the VLAN
range), it is possible to reset the switch to factory settings.
To factory default a switch, turn the encoder knob to the switch main menu, which is the default menu showing the switch's
name and IP address. Click in the encoder to access the main menu.
Scroll the encoder knob until "Admin/Security" is highlighted, and click in the knob. Under the Admin/Security menu, scroll
down to "Factory Default", and click in the knob.
This will show the Factory Default menu. Here you have several options.
July 2021
Rotary Encoder
Turn to Highlight
Push to Select
TM
Base Configuration
Network Setup
Device Info/Status
Advanced Settings
Admin/Security
<Back>
Admin/Security
Factory Default
Manage Restore Point
Reset Security
Reboot
<Back>
Factory Default
Keep Net Setup & Restore Pt.
Keep Restore Point
Wipe All Configuration
<Back>
PWVIA RM P12 Ethernet Switches - Manual
LINK/ACT
PORT 1
PORT 2
PORT 3
PORT 4
PORT 5
PORT 6
53
Advertisement
Table of Contents
