Vlan Properties; Art-Net Trap And Convert - pathway VIA PWVIA RM P12 User Manual

VLAN PROPERTIES

Set VLAN Properties for the selected port.
VLAN TAGGED
When VLANs are enabled, set port as a Tagged/Uplink to transmit all VLANs' data between switches. Typically tagged
ports are only used to connect a switch to a switch. Although it is possible to make a PC's NIC tagged, Pathway gateways
and controllers do not used tagged NICs. If you cannot communicate with a gateway or controller, check that the port your
PC is using and the port the devices is on are not tagged and on the same VLAN.
For most applications, ports connected to end devices should be set as Untagged (default).
VLAN
Sets the VLAN ID# used by the port. Only applies to untagged ports when VLANs have been enabled.

Art-Net TRAP AND CONVERT

See also Art-Net Alternate Mapping in the base device properties.
TX PROTOCOL
Disabled (default).
E1.31 sACN: Any inbound Art-Net broadcast packets are converted to E1.31 sACN multicast data packets using the same
Universe number as originally transmitted. On large systems using sACN, you should enable IGMP to reduce network traffic.
Pathway ssACN: Any inbound Art-Net broadcast packets are converted to Pathway Secure sACN (ssACN) multicast
data packets using the same Universe number as originally transmitted. On large systems using sACN, you should enable
IGMP to reduce network traffic.
July 2021 PWVIA RM P12 Ethernet Switches - Manual
49