Device Info/Status - pathway VIA PWVIA RM P12 User Manual

DEVICE INFO/STATUS

This menu allows review of several device properties. These are non-editable.
Menu Item
Serial #
MAC
Firmware Version
Ring Protect State (if
enabled)
PoE Used
PoE Allocated
PoE Remaining
<Back>
IMPORTANT: VIA model PWVIA RM P12 RJ45EC [xxxx] NONPOE hardware does not support PoE. Connected PoE-
enabled devices will not receive power from the switch.
VIA models PWVIA RM P12 RJ45EC [xxxx] POE have 100W of on-board PoE power. Connecting PoE-enabled devices will
allow them to be powered by the switch.
60
Device Info/Status
Serial #: PPXXXXXXX
MAC: XX:XX:XX:XX:XX:XX
Firmware Version: 6.0
PoE Used: 7.0W
PoE Allocated: 50.0W
PoE Remaining: 50.0W
<Back>
Factory-assigned, Pathway serial number. Read-only.
Factory-assigned media access control (MAC) address. Read-only.
Current operating firmware version. Firmware may be updated using Pathscape. Read-
only.
OK: Ring is intact
Init: Ring is initializing
Failed: Link between two ports has failed. Communication now relies on secondary
links. Fault should be located and repaired immediately.
Total Power-over-Ethernet being drawn by all connected devices, in Watts.
Total current Power-over-Ethernet budgeted to all ports, in Watts
Total unallocated Power-over-Ethernet available from PoE power supply
Returns to previous menu
PWVIA RM P12 Ethernet Switches - Manual
Description
July 2021