Table of Contents
Advertisement
FRONT PANEL UI AND MENU
The PWVIA RM P12 models feature a front panel UI, consisting of an LCD and a rotary pushbutton encoder for navigating
menus and selecting options.
If configuring the switch VIA a PC and Pathscape is not possible or practical, it is still easy to do using the front panel UI. This
section will show the menu structure and descriptions of menu options.
SETTING SECURITY MODE
When the device boots up for the first time, or if it has been Factory Defaulted or had its Security Settings reset, the Security
Mode screen will be shown.
Before you can configure and use the device, you must either:
• Use Pathscape to Secure the device (Add it to a Security Domain). No input from the front panel is required
here. Clicking the encoder knob to select Wait for Pathscape to Secure will show the device Serial Number and MAC
Address, in cases where this may be helpful for device identification.
• Enable Local Configuration Only (Read only) mode. Turn the encoder to select Local Configuration Only. In the
submenu, confirm by selecting Local Configuration Only again. You will then have full access to the menus.
July 2021
Rotary Encoder
Turn to Highlight
Push to Select
TM
Security Mode
Wait for Pathscape to Secure
Local Configuration Only
Disable Security
Wait for Pathscape to Secure
Serial # : PPXXXXXXX
MAC : XX:XX:XX:XX:XX:XX
<Back>
PWVIA RM P12 Ethernet Switches - Manual
LINK/ACT
PORT 1
PORT 2
PORT 3
PORT 4
PORT 5
PORT 6
55
Advertisement
Table of Contents
