Poe Properties (Not Shown On Nonpoe Model) - pathway VIA PWVIA RM P12 User Manual

NOTES ON Art-Net TRAP AND CONVERT
When enabled, Art-Net data packets with broadcast address destinations are trapped and converted to E1.31 sACN
multicast packets, as the packets enter the port of the switch. The resulting sACN packets may then be filtered using the
IGMP settings.
Art-Net Trap and Convert is a port-level property; it can be enabled on a port-by-port basis.
When enabled, Art-Net data packets with broadcast address destinations are trapped and converted to E1.31 sACN
multicast packets, as the packets enter the port of the switch. The resulting multicast sACN packets may then be filtered
using the IGMP settings. All other Art-Net broadcast packets, such as ArtPoll, are discarded. Depending on the amount
of Art-Net data traffic, this operation could significantly improve bandwidth usage efficiency and reduce the amount of
unnecessary traffic seen by end devices.
The Art-Net packet will be converted to the analogous sACN universe. Due to how Art-Net universes are numbered, there
is the possibility of an off-by-one error. Change the "Art-Net Alternate Mapping" option should the universe mapping seem
incorrect.
Although performance depends on DMX frame rate, conversion of no more than 48 Art-Net universes by one VIA at one
time is recommended.
When this feature is disabled, Art-Net data will be routed as normal broadcast traffic to all devices on the current VLAN.

POE PROPERTIES (NOT SHOWN ON NONPOE Model)

PoE
Enabled (default): Port will attempt to power any connected PoE-compliant device.
Disabled: PoE will not be provided to end devices.
PoE STATUS
PoE Class as reported by end device. Read-only.
Not Detected (end device not PoE)
Class 0 (15.4W)
Class 1 (5.4W)
Class 2 (11.7W)
Class 3 (15.4W)
50
PWVIA RM P12 Ethernet Switches - Manual July 2021