Kohler 24RCL Manual page 8

when standing in water or on wet
ground because these conditions
increase the risk of electrocution.
Disconnecting the electrical load.
Hazardous voltage can
severe injury or death. Disconnect
the generator set from the load by
turning off the line circuit breaker or by
disconnecting the generator set output
leads from the transfer switch and
heavily taping the ends of the leads.
High voltage transferred to the load
during testing may cause personal
injury and equipment damage.
Engine block heater.
voltage can cause severe injury or
death. The engine block heater can
cause electrical shock. Remove the
engine block heater plug from the
electrical outlet before working on the
block heater electrical connections.
High voltage test.
voltage can cause severe injury or
death. Follow the instructions of the
test equipment manufacturer when
performing high-voltage tests on the
rotor or stator. An improper test
procedure can damage equipment or
lead to generator set failure.
Connecting the battery and the
battery charger. Hazardous voltage
can cause severe injury or death.
Reconnect the battery
positive to positive and negative to
negative, to avoid electrical shock and
damage to the battery charger and
battery(ies). Have a
electrician install the battery(ies).
8 Safety Precautions and Instructions
Servicing the generator set when it
is operating. Exposed moving parts
can cause severe injury or death.
Keep hands, feet, hair, clothing, and
test leads away from the belts and
cause
pulleys when the generator set is
running. Replace guards, screens, and
covers before operating the generator
set.
Short
voltage/current can cause severe
injury or death. Short circuits can
cause bodily injury and/or equipment
damage.
connections with tools or jewelry while
Hazardous
making
Remove all jewelry before servicing the
equipment.
Electrical backfeed to the utility.
Hazardous backfeed voltage can
cause severe injury or death. Install
a transfer switch in standby power
Hazardous
installations to prevent the connection
of standby and other sources of power.
Electrical
electrical system can cause severe
injury or death to utility personnel
working on power lines.
correctly,
qualified
circuits. Hazardous
Do not contact electrical
adjustments or repairs.
backfeed into a utility
Welding on the generator set. Can
cause severe electrical equipment
damage. Before welding on the
generator set perform the following
steps: (1) Remove the battery cables,
negative (--) lead first. (2) Disconnect
all engine electronic control module
(ECM) connectors. (3) Disconnect all
generator set controller and voltage
regulator circuit board connectors.
(4) Disconnect the engine battery-
charging alternator connections.
(5) Attach the weld ground connection
close to the weld location.
Testing live electrical
Hazardous voltage or current can
cause severe injury or death. Have
trained and qualified personnel take
diagnostic measurements
circuits. Use adequately rated test
equipment with electrically insulated
probes and follow the instructions of the
test equipment manufacturer when
performing voltage tests. Observe the
following precautions when performing
voltage tests: (1) Remove all jewelry.
(2) Stand on a dry, approved electrically
insulated mat. (3) Do not touch the
enclosure or components inside the
enclosure. (4) Be prepared for the
system to operate automatically.
(600 volts and under)
TP-6907 5/16
circuits.
of live