Setting The Oncue Plus Password - Kohler 24RCL Manual

3.8 Setting the OnCue Plus
Password
If the Kohlerr OnCuer Plus Generator Management
System is used to monitor the generator set, reset the
OnCue password as described below.
Refer to Figure 3-16 during this procedure.
1. Press Select and then press the down arrow button
to navigate to the networking Information menu.
2. Press Select. Networking Status is displayed.
3. Press the Down arrow button.
Configuration is displayed.
Networking---->
Information
Figure 3-16 Setting the OnCue Plus Password, RDC2
TP-6907 5/16
Networking
Networking---->
Status
Networking
Reset OnCue
Configuration
Password
<---- Return
4. Press Select.
displayed.
5. Press and HOLD the Select button until Reset
OnCue Password? No appears. The word No will
flash.
6. Press the Up arrow button to change the word No to
Yes.
7. Press Select to reset the password. The generator
set serial number and new password are displayed
for 10 seconds. Be sure to write down the new
password for entry into the OnCue Plus program.
HOLD
DHCP:
Enabled
Reset OnCue Password is
Reset OnCue
Password? No
UP arrow for YES,
Down arrow for NO.
Reset OnCue
Password? Yes
Press Select to enter YES
or NO as displayed. New
password is displayed for
approximately 10 seconds.
S/N: 1234567
New PW: 12345
Section 3 Controller
tp6804
53